The amplitude of a watch movement indicates sufficient energy transmission. Amplitude is found by measuring the rotation in which the balance wheel of a running watch swings back and forth. It is measured in degrees and is a great way to check the mechanical health of your watch, and more specifically the mainspring’s ability to deliver needed power.
This is how Witschi, a well-known Swiss manufacturer of testing equipment, describes amplitude in their documentation:
The amplitude is the angle from the equilibrium (idle position of the balance wheel) up to the maximum distance (turning point). The amplitude values of today’s popular wristwatches are located at about 260° – 310°. With increasing aging of the oils, this value decreases gradually.
How to Measure Amplitude?
A timegrapher is needed to get a precise measurement of amplitude. To get an accurate reading of the watch’s amplitude, you will need to know the correct lift angle of the watch. Most of the caliber listings on Caliber Corner have this information listed in the specs chart.
Amplitude should be measured with the movement fully wound. Because amplitude can vary depending on the dial position of the watch, you will want to test in multiple positions. Amplitude is typically higher in dial up position and lower in vertical positions.
Normal Amplitude Range:
The exact numbers are often debated in the community, and it depends on the caliber, but excellent amplitude is said to be within 270-315 degrees on modern watches. You may see acceptable amplitude as low as 250. Amplitude of 360 means the balance wheel is completing a full circle rotation.
Low Amplitude – A low amplitude reading can indicate issues with the mainspring. Lower amplitude often means that insufficient energy is being transmitted to the escapement. Watches with low amplitude generally lose time.
High Amplitude – High amplitude can cause what is known as knocking the banking. This can cause damage to the roller jewel from knocking against the other side of the pallet fork.