I want to install watch hands on a skeleton movement. Normally, the hour wheel is kept in place by the dial. But here, no dial! How should I proceed? Thanks!
Hour wheel?. Hour hand? Please clarify.
The problem I see is with the hour wheel that is not held in place by the dial, as usual. How do you ensure that it does not slip out of position ? Thanks !
Hi JFoto51, welcome to the site!
This video gives a close-up of the front and back of a skeletonized Seagull ST3600K (6497 clone), including the hour wheel...
Thanks for the video. It does show the hour wheel, albeit briefly, and a profile view would have been interesting. I have the same movement on my bench and will fiddle around with it to see what I can do. Thanks again and don’t hesitate if you come across more info.
Nice video and movement. good luck becasue I am thinking you are the first down this road.
network of watch sites
Recent Comments
This screw number is for 4002X, 4003X, 4120X, 4210X, 4220X, 5010X, 5020X, 5021X, 5040X, 5030X,…
Tag Heuer WS2110-2 (1000 Superprofessional)
Feel free to post off-topic questions in the forum.
Very interesting, thank you! I will check out your YT channel. Off topic ... but…
It's just back-ratcheting, and another common debate in the watch community. Some say it is…
Here's a Q for you. When some people wind the crown - thumb towards 12-o'clock…
It depends on another variable: the person's fingers. A smaller crown can be harder to…